Tam Valley Depot - All Scales - DCC - Set of 8 L-brackets and screw for mounting 4 servos. Works well for semaphores. (SKU 7040-LBR001)
Available On: April 1, 2019
The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed
Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor. Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1).
Skill Level: Intermediate to control from pushbuttons to Advanced to connect to a signal system.
This is a nice way to mount servos for operating a semaphore blade. The kit works well for both miniature (SG90) and standard size servos. The kit includes (8) 3/8" L-brackets and (8) #4-40x1/4" screws for mounting four servos.