The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

24 AWG 3-wire servo extension cable. Set of 10 40" extension cables.

How many of these can you daisy chain together?  In an experiment I daisy-chained 15 extensions and found that the servo still worked OK.  At 20 extensions, the servo threw but could not hold against back-pressure.  So I would say up to 15 40cm extensions is the limit - that's 50 feet.

Can also be used for Fascia Controllers.