The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

Y cables are used to attach two servos to one output.  Both servos will move in the same manner at the same time.  Could be used, for example, to control a crossover or a passing siding.  Does not affect the servo power.  The Y can can also be used with the fascia controllers for the Quad-Pic to provide two control points for one switch.  Use one for a pair of servos and one for a controller at the same time and you can set up a passing siding with control points at both ends!

Y servo extension
Y cables are used to attach two servos to one output.  Both servos will move in the same manner at the same time.  Could be used, for example, to control a crossover or a passing siding.  Does not affect the servo power.  The Y can can also be used with the fascia controllers for the Quad-Pic to provide two control points for one switch.  Use one for a pair of servos and one for a controller at the same time and you can set up a passing siding with control points at both ends!