The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

The Micro Switch Machine is based on the SG90 servo with a 5 Amp rated snap switch mounted so that it is turned on and off at half throw - ideal for powering frogs.  The wire actuator is already mounted for you.  The Micro Switch Machine is ready to go.  Comes with a piece of double-sided foam tape for ease of mounting as well as two #4x1/2" screws for permanent mounting.  The #4 screws fit snugly in the mounting holes so that they will not fall out when you are under the layout :). Use with any of your servo decoders to power a turnout and the contacts provide frog power.

Comes with foam tape and screws for mounting under the layout.