The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

Jumper wires to simplify connections to the boards.

Pre-crimped and shrouded jumper wires in a ranbow of colors.  The wires are easily seperated in to singles and bundles just by pulling.

The Male pins fit nicely in to terminal blocks.

The Female jumper wires connect to the gold pin 0.1" headers used on our boards.

12" Jumper Wires for Pin Headers and Terminal Blocks (Pack of 40 male - male rainbow colored wires)

These handy wires have pre-crimped female connectors (F) that mate with the gold header pins used on many of our boards or male pins (M) that can fit in terminal blocks or act as extensions.  They come with square plastic shrouds that prevent accididental shorts.  You can get them in 3 varieties M-F, M-M and F-F.  The M-F are particualarly nice because they plug in to one another to extend for a longer run.

They come in rainbow colors with a repeating pattern of 10 colors.  A total of 40 wires come together in a bundle.  They are easily pulled apart so they can be used in groups or one at a time. At this price they are just 15 cents each. They are 30cm in length which just shy of 12".

 Ruler shown for scale