The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

LED Fascia Controller Kit

Contains PC boards and parts needed to build 4 fascia controllers with bi-color LEDs (3-lead type). The resistors and transistors are pre-mounted and the board tested.  An advantage of building from the kit is that you can mount the components on a control panel anywhere you wish and then wire them back to the PC board.  Servo extension cord not included in kit.