The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

Remote Aligner for QuadLN and QuadLN_S

 
Used with the QuadLN_S (above) for alignment of servos.  Just one of these needed for all of your QuadLN_Ss.  Comes with a 10' cable which allows you to stand next to your turnout while aligning the servo - no more acrobatics and hanging upside down below the layout!  

Board is 2.7" x 1.7" in size.