The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

Signal Board for QuadLN_S

 
Plugs in to the expansion port of the QuadLN_S to provide for 24 LEDs to drive signals.

Board is 4.25" x 1.35" in size.  Extends 3.6" from QuadLN_S.

Signal Board comes with standoffs and screws for mounting.