The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

Singlet II Servo Decoder Kit

 
Includes the PC board but without the LED and pushbuttons mounted. Includes 2 5mm bi-color LEDs and 2 pushbuttons loose and ready to mount as you wish. 

This lets you remotely install LEDs or pushbuttons to integrate into your own style of control panel. 

There are alternate inputs you can take advantage of in the kit. 

These inputs will accept either a toggle switch or a single pushbutton (each push alternates the points). 

You need to be comfortable with soldering to assemble the kit.

Note LEDS are bicolor red/green in the kit same as the factory assembled unit.