You asked us if it would be possible to power and change the signals directly from our Cobalt Turnout Motors - so we listened and created a very clever little product which allows our Ground Signals to be linked directly to Cobalt Turnout Motors with no additional power source or switching!

The Ground Signal Interface Board couldn’t be simpler to install! Use the included leads to connect to the Cobalt iP Digital, iP Analog or Omega turnout motor, then plug in your Alpha Mimic Ground Signals. It really is that easy! Take a look at the connection instructions below (click the image to see it full size)...

Available in single or triple packs, everything you need to connect your Alpha Mimic Ground Signals is included. When you change your turnout, the aspect on your signal will then change automatically!

We carefully designed the Ground Signal Interface Board to fit neatly into this recess on the side of your Cobalt Turnout Motor to keep things really tidy under the baseboard! Just use a small piece of double- sided tape to hold the board in place.

Available either individually or in a handy triple pack, the Ground Signal Interface Board also represents fantastic value when combined with our Alpha Mimic Ground Signal Packs!